6.0L Powerstroke

IPR Repair Kit

- You may not need a new IPR Valve! -

- UPDATED TOUGH STAINLESS SCREEN -

(fits all 2003 - 2010 6.0L)

also fits International VT275 and VT365

The IPR Valve on your Powerstroke is responsible for controlling the pressure in the high-pressure oil system which in turn operates the fuel injectors. The IPR (injection pressure regulator) is located on the high pressure oil pump at the front of the engine's valley. Because of the high pressures they are responsible for controlling, the IPR valve o-rings are a semi-common failure which will in turn result in such low oil pressure related symptoms as poor idle, stalling, and even a no-start condition. While there are other potential causes for symptoms of bad IPR 6.0, such as a failed IPR valve, the o-rings themselves are often at fault, and are much less expensive to replace. The IPR valve screen is another common failure. The screen may become plugged with debris and be collapsed by the flow of high pressure oil as it tries to flow through the restricted screen. A torn screen will allow debris to enter the IPR valve which may damage the valve.

The filter included in this 6.0L Powerstroke IPR valve repair kit is an updated design made from strong stainless steel sheet instead of the previous brass screen design to better resist tearing which can result in a jammed IPR valve and no-start condition. Even if your IPR screen is not torn or damaged, we would recommend upgrading for improved reliability.

This kit includes:

(1) Backup ring
(1) Orifice O-ring
(1) O-ring seal
(1) IPR Screen

Use in place of the following part numbers: 3C3Z9H529A, AP0035